diff options
Diffstat (limited to 'drivers/net/cxgb3/t3_hw.c')
| -rw-r--r-- | drivers/net/cxgb3/t3_hw.c | 80 |
1 files changed, 57 insertions, 23 deletions
diff --git a/drivers/net/cxgb3/t3_hw.c b/drivers/net/cxgb3/t3_hw.c index ff262a04ded0..31ed31a3428b 100644 --- a/drivers/net/cxgb3/t3_hw.c +++ b/drivers/net/cxgb3/t3_hw.c @@ -493,20 +493,20 @@ int t3_phy_lasi_intr_handler(struct cphy *phy) } static const struct adapter_info t3_adap_info[] = { - {2, 0, + {1, 1, 0, F_GPIO2_OEN | F_GPIO4_OEN | F_GPIO2_OUT_VAL | F_GPIO4_OUT_VAL, { S_GPIO3, S_GPIO5 }, 0, &mi1_mdio_ops, "Chelsio PE9000"}, - {2, 0, + {1, 1, 0, F_GPIO2_OEN | F_GPIO4_OEN | F_GPIO2_OUT_VAL | F_GPIO4_OUT_VAL, { S_GPIO3, S_GPIO5 }, 0, &mi1_mdio_ops, "Chelsio T302"}, - {1, 0, + {1, 0, 0, F_GPIO1_OEN | F_GPIO6_OEN | F_GPIO7_OEN | F_GPIO10_OEN | F_GPIO11_OEN | F_GPIO1_OUT_VAL | F_GPIO6_OUT_VAL | F_GPIO10_OUT_VAL, { 0 }, SUPPORTED_10000baseT_Full | SUPPORTED_AUI, &mi1_mdio_ext_ops, "Chelsio T310"}, - {2, 0, + {1, 1, 0, F_GPIO1_OEN | F_GPIO2_OEN | F_GPIO4_OEN | F_GPIO5_OEN | F_GPIO6_OEN | F_GPIO7_OEN | F_GPIO10_OEN | F_GPIO11_OEN | F_GPIO1_OUT_VAL | F_GPIO5_OUT_VAL | F_GPIO6_OUT_VAL | F_GPIO10_OUT_VAL, @@ -514,7 +514,7 @@ static const struct adapter_info t3_adap_info[] = { &mi1_mdio_ext_ops, "Chelsio T320"}, {}, {}, - {1, 0, + {1, 0, 0, F_GPIO1_OEN | F_GPIO2_OEN | F_GPIO4_OEN | F_GPIO6_OEN | F_GPIO7_OEN | F_GPIO10_OEN | F_GPIO1_OUT_VAL | F_GPIO6_OUT_VAL | F_GPIO10_OUT_VAL, { S_GPIO9 }, SUPPORTED_10000baseT_Full | SUPPORTED_AUI, @@ -2128,16 +2128,40 @@ void t3_port_intr_clear(struct adapter *adapter, int idx) static int t3_sge_write_context(struct adapter *adapter, unsigned int id, unsigned int type) { - t3_write_reg(adapter, A_SG_CONTEXT_MASK0, 0xffffffff); - t3_write_reg(adapter, A_SG_CONTEXT_MASK1, 0xffffffff); - t3_write_reg(adapter, A_SG_CONTEXT_MASK2, 0xffffffff); - t3_write_reg(adapter, A_SG_CONTEXT_MASK3, 0xffffffff); + if (type == F_RESPONSEQ) { + /* + * Can't write the Response Queue Context bits for + * Interrupt Armed or the Reserve bits after the chip + * has been initialized out of reset. Writing to these + * bits can confuse the hardware. + */ + t3_write_reg(adapter, A_SG_CONTEXT_MASK0, 0xffffffff); + t3_write_reg(adapter, A_SG_CONTEXT_MASK1, 0xffffffff); + t3_write_reg(adapter, A_SG_CONTEXT_MASK2, 0x17ffffff); + t3_write_reg(adapter, A_SG_CONTEXT_MASK3, 0xffffffff); + } else { + t3_write_reg(adapter, A_SG_CONTEXT_MASK0, 0xffffffff); + t3_write_reg(adapter, A_SG_CONTEXT_MASK1, 0xffffffff); + t3_write_reg(adapter, A_SG_CONTEXT_MASK2, 0xffffffff); + t3_write_reg(adapter, A_SG_CONTEXT_MASK3, 0xffffffff); + } t3_write_reg(adapter, A_SG_CONTEXT_CMD, V_CONTEXT_CMD_OPCODE(1) | type | V_CONTEXT(id)); return t3_wait_op_done(adapter, A_SG_CONTEXT_CMD, F_CONTEXT_CMD_BUSY, 0, SG_CONTEXT_CMD_ATTEMPTS, 1); } +/** + * clear_sge_ctxt - completely clear an SGE context + * @adapter: the adapter + * @id: the context id + * @type: the context type + * + * Completely clear an SGE context. Used predominantly at post-reset + * initialization. Note in particular that we don't skip writing to any + * "sensitive bits" in the contexts the way that t3_sge_write_context() + * does ... + */ static int clear_sge_ctxt(struct adapter *adap, unsigned int id, unsigned int type) { @@ -2145,7 +2169,14 @@ static int clear_sge_ctxt(struct adapter *adap, unsigned int id, t3_write_reg(adap, A_SG_CONTEXT_DATA1, 0); t3_write_reg(adap, A_SG_CONTEXT_DATA2, 0); t3_write_reg(adap, A_SG_CONTEXT_DATA3, 0); - return t3_sge_write_context(adap, id, type); + t3_write_reg(adap, A_SG_CONTEXT_MASK0, 0xffffffff); + t3_write_reg(adap, A_SG_CONTEXT_MASK1, 0xffffffff); + t3_write_reg(adap, A_SG_CONTEXT_MASK2, 0xffffffff); + t3_write_reg(adap, A_SG_CONTEXT_MASK3, 0xffffffff); + t3_write_reg(adap, A_SG_CONTEXT_CMD, + V_CONTEXT_CMD_OPCODE(1) | type | V_CONTEXT(id)); + return t3_wait_op_done(adap, A_SG_CONTEXT_CMD, F_CONTEXT_CMD_BUSY, + 0, SG_CONTEXT_CMD_ATTEMPTS, 1); } /** @@ -2729,10 +2760,10 @@ static void tp_config(struct adapter *adap, const struct tp_params *p) F_TCPCHECKSUMOFFLOAD | V_IPTTL(64)); t3_write_reg(adap, A_TP_TCP_OPTIONS, V_MTUDEFAULT(576) | F_MTUENABLE | V_WINDOWSCALEMODE(1) | - V_TIMESTAMPSMODE(0) | V_SACKMODE(1) | V_SACKRX(1)); + V_TIMESTAMPSMODE(1) | V_SACKMODE(1) | V_SACKRX(1)); t3_write_reg(adap, A_TP_DACK_CONFIG, V_AUTOSTATE3(1) | V_AUTOSTATE2(1) | V_AUTOSTATE1(0) | - V_BYTETHRESHOLD(16384) | V_MSSTHRESHOLD(2) | + V_BYTETHRESHOLD(26880) | V_MSSTHRESHOLD(2) | F_AUTOCAREFUL | F_AUTOENABLE | V_DACK_MODE(1)); t3_set_reg_field(adap, A_TP_IN_CONFIG, F_RXFBARBPRIO | F_TXFBARBPRIO, F_IPV6ENABLE | F_NICMODE); @@ -3196,20 +3227,22 @@ int t3_mps_set_active_ports(struct adapter *adap, unsigned int port_mask) } /* - * Perform the bits of HW initialization that are dependent on the number - * of available ports. + * Perform the bits of HW initialization that are dependent on the Tx + * channels being used. */ -static void init_hw_for_avail_ports(struct adapter *adap, int nports) +static void chan_init_hw(struct adapter *adap, unsigned int chan_map) { int i; - if (nports == 1) { + if (chan_map != 3) { /* one channel */ t3_set_reg_field(adap, A_ULPRX_CTL, F_ROUND_ROBIN, 0); t3_set_reg_field(adap, A_ULPTX_CONFIG, F_CFG_RR_ARB, 0); - t3_write_reg(adap, A_MPS_CFG, F_TPRXPORTEN | F_TPTXPORT0EN | - F_PORT0ACTIVE | F_ENFORCEPKT); - t3_write_reg(adap, A_PM1_TX_CFG, 0xffffffff); - } else { + t3_write_reg(adap, A_MPS_CFG, F_TPRXPORTEN | F_ENFORCEPKT | + (chan_map == 1 ? F_TPTXPORT0EN | F_PORT0ACTIVE : + F_TPTXPORT1EN | F_PORT1ACTIVE)); + t3_write_reg(adap, A_PM1_TX_CFG, + chan_map == 1 ? 0xffffffff : 0); + } else { /* two channels */ t3_set_reg_field(adap, A_ULPRX_CTL, 0, F_ROUND_ROBIN); t3_set_reg_field(adap, A_ULPTX_CONFIG, 0, F_CFG_RR_ARB); t3_write_reg(adap, A_ULPTX_DMA_WEIGHT, @@ -3517,7 +3550,7 @@ int t3_init_hw(struct adapter *adapter, u32 fw_params) t3_write_reg(adapter, A_PM1_RX_CFG, 0xffffffff); t3_write_reg(adapter, A_PM1_RX_MODE, 0); t3_write_reg(adapter, A_PM1_TX_MODE, 0); - init_hw_for_avail_ports(adapter, adapter->params.nports); + chan_init_hw(adapter, adapter->params.chan_map); t3_sge_init(adapter, &adapter->params.sge); t3_write_reg(adapter, A_T3DBG_GPIO_ACT_LOW, calc_gpio_intr(adapter)); @@ -3754,7 +3787,8 @@ int t3_prep_adapter(struct adapter *adapter, const struct adapter_info *ai, get_pci_mode(adapter, &adapter->params.pci); adapter->params.info = ai; - adapter->params.nports = ai->nports; + adapter->params.nports = ai->nports0 + ai->nports1; + adapter->params.chan_map = !!ai->nports0 | (!!ai->nports1 << 1); adapter->params.rev = t3_read_reg(adapter, A_PL_REV); /* * We used to only run the "adapter check task" once a second if @@ -3785,7 +3819,7 @@ int t3_prep_adapter(struct adapter *adapter, const struct adapter_info *ai, mc7_prep(adapter, &adapter->pmtx, MC7_PMTX_BASE_ADDR, "PMTX"); mc7_prep(adapter, &adapter->cm, MC7_CM_BASE_ADDR, "CM"); - p->nchan = ai->nports; + p->nchan = adapter->params.chan_map == 3 ? 2 : 1; p->pmrx_size = t3_mc7_size(&adapter->pmrx); p->pmtx_size = t3_mc7_size(&adapter->pmtx); p->cm_size = t3_mc7_size(&adapter->cm); |