diff options
Diffstat (limited to 'arch')
| -rw-r--r-- | arch/i386/kernel/asm-offsets.c | 1 | ||||
| -rw-r--r-- | arch/i386/kernel/entry.S | 16 | ||||
| -rw-r--r-- | arch/i386/xen/enlighten.c | 1 | ||||
| -rw-r--r-- | arch/i386/xen/xen-asm.S | 185 | ||||
| -rw-r--r-- | arch/i386/xen/xen-ops.h | 1 |
5 files changed, 199 insertions, 5 deletions
diff --git a/arch/i386/kernel/asm-offsets.c b/arch/i386/kernel/asm-offsets.c index a7c2947b3966..25f7eb513928 100644 --- a/arch/i386/kernel/asm-offsets.c +++ b/arch/i386/kernel/asm-offsets.c @@ -61,6 +61,7 @@ void foo(void) OFFSET(TI_addr_limit, thread_info, addr_limit); OFFSET(TI_restart_block, thread_info, restart_block); OFFSET(TI_sysenter_return, thread_info, sysenter_return); + OFFSET(TI_cpu, thread_info, cpu); BLANK(); OFFSET(GDS_size, Xgt_desc_struct, size); diff --git a/arch/i386/kernel/entry.S b/arch/i386/kernel/entry.S index ffb236544270..32980b834935 100644 --- a/arch/i386/kernel/entry.S +++ b/arch/i386/kernel/entry.S @@ -1030,7 +1030,21 @@ ENTRY(xen_hypervisor_callback) CFI_ADJUST_CFA_OFFSET 4 SAVE_ALL TRACE_IRQS_OFF - mov %esp, %eax + + /* Check to see if we got the event in the critical + region in xen_iret_direct, after we've reenabled + events and checked for pending events. This simulates + iret instruction's behaviour where it delivers a + pending interrupt when enabling interrupts. */ + movl PT_EIP(%esp),%eax + cmpl $xen_iret_start_crit,%eax + jb 1f + cmpl $xen_iret_end_crit,%eax + jae 1f + + call xen_iret_crit_fixup + +1: mov %esp, %eax call xen_evtchn_do_upcall jmp ret_from_intr CFI_ENDPROC diff --git a/arch/i386/xen/enlighten.c b/arch/i386/xen/enlighten.c index 4fa62a4cb7cc..9a8c1181c001 100644 --- a/arch/i386/xen/enlighten.c +++ b/arch/i386/xen/enlighten.c @@ -838,6 +838,7 @@ void __init xen_setup_vcpu_info_placement(void) paravirt_ops.irq_disable = xen_irq_disable_direct; paravirt_ops.irq_enable = xen_irq_enable_direct; paravirt_ops.read_cr2 = xen_read_cr2_direct; + paravirt_ops.iret = xen_iret_direct; } } diff --git a/arch/i386/xen/xen-asm.S b/arch/i386/xen/xen-asm.S index dc4d36d51bc1..1a43b60c0c62 100644 --- a/arch/i386/xen/xen-asm.S +++ b/arch/i386/xen/xen-asm.S @@ -12,15 +12,21 @@ */ #include <linux/linkage.h> + #include <asm/asm-offsets.h> #include <asm/thread_info.h> #include <asm/percpu.h> -#include <asm/asm-offsets.h> #include <asm/processor-flags.h> +#include <asm/segment.h> + +#include <xen/interface/xen.h> #define RELOC(x, v) .globl x##_reloc; x##_reloc=v #define ENDPATCH(x) .globl x##_end; x##_end=. +/* Pseudo-flag used for virtual NMI, which we don't implement yet */ +#define XEN_EFLAGS_NMI 0x80000000 + /* Enable events. This clears the event mask and tests the pending event status with one and operation. If there are pending @@ -81,13 +87,12 @@ ENDPATCH(xen_save_fl_direct) */ ENTRY(xen_restore_fl_direct) testb $X86_EFLAGS_IF>>8, %ah - setz %al - movb %al, PER_CPU_VAR(xen_vcpu_info)+XEN_vcpu_info_mask + setz PER_CPU_VAR(xen_vcpu_info)+XEN_vcpu_info_mask /* Preempt here doesn't matter because that will deal with any pending interrupts. The pending check may end up being run on the wrong CPU, but that doesn't hurt. */ - /* check for pending but unmasked */ + /* check for unmasked and pending */ cmpw $0x0001, PER_CPU_VAR(xen_vcpu_info)+XEN_vcpu_info_pending jz 1f 2: call check_events @@ -97,6 +102,178 @@ ENDPATCH(xen_restore_fl_direct) ENDPROC(xen_restore_fl_direct) RELOC(xen_restore_fl_direct, 2b+1) +/* + This is run where a normal iret would be run, with the same stack setup: + 8: eflags + 4: cs + esp-> 0: eip + + This attempts to make sure that any pending events are dealt + with on return to usermode, but there is a small window in + which an event can happen just before entering usermode. If + the nested interrupt ends up setting one of the TIF_WORK_MASK + pending work flags, they will not be tested again before + returning to usermode. This means that a process can end up + with pending work, which will be unprocessed until the process + enters and leaves the kernel again, which could be an + unbounded amount of time. This means that a pending signal or + reschedule event could be indefinitely delayed. + + The fix is to notice a nested interrupt in the critical + window, and if one occurs, then fold the nested interrupt into + the current interrupt stack frame, and re-process it + iteratively rather than recursively. This means that it will + exit via the normal path, and all pending work will be dealt + with appropriately. + + Because the nested interrupt handler needs to deal with the + current stack state in whatever form its in, we keep things + simple by only using a single register which is pushed/popped + on the stack. + + Non-direct iret could be done in the same way, but it would + require an annoying amount of code duplication. We'll assume + that direct mode will be the common case once the hypervisor + support becomes commonplace. + */ +ENTRY(xen_iret_direct) + /* test eflags for special cases */ + testl $(X86_EFLAGS_VM | XEN_EFLAGS_NMI), 8(%esp) + jnz hyper_iret + + push %eax + ESP_OFFSET=4 # bytes pushed onto stack + + /* Store vcpu_info pointer for easy access. Do it this + way to avoid having to reload %fs */ +#ifdef CONFIG_SMP + GET_THREAD_INFO(%eax) + movl TI_cpu(%eax),%eax + movl __per_cpu_offset(,%eax,4),%eax + lea per_cpu__xen_vcpu_info(%eax),%eax +#else + movl $per_cpu__xen_vcpu_info, %eax +#endif + + /* check IF state we're restoring */ + testb $X86_EFLAGS_IF>>8, 8+1+ESP_OFFSET(%esp) + + /* Maybe enable events. Once this happens we could get a + recursive event, so the critical region starts immediately + afterwards. However, if that happens we don't end up + resuming the code, so we don't have to be worried about + being preempted to another CPU. */ + setz XEN_vcpu_info_mask(%eax) +xen_iret_start_crit: + + /* check for unmasked and pending */ + cmpw $0x0001, XEN_vcpu_info_pending(%eax) + + /* If there's something pending, mask events again so we + can jump back into xen_hypervisor_callback */ + sete XEN_vcpu_info_mask(%eax) + + popl %eax + + /* From this point on the registers are restored and the stack + updated, so we don't need to worry about it if we're preempted */ +iret_restore_end: + + /* Jump to hypervisor_callback after fixing up the stack. + Events are masked, so jumping out of the critical + region is OK. */ + je xen_hypervisor_callback + + iret +xen_iret_end_crit: + +hyper_iret: + /* put this out of line since its very rarely used */ + jmp hypercall_page + __HYPERVISOR_iret * 32 + + .globl xen_iret_start_crit, xen_iret_end_crit + +/* + This is called by xen_hypervisor_callback in entry.S when it sees + that the EIP at the time of interrupt was between xen_iret_start_crit + and xen_iret_end_crit. We're passed the EIP in %eax so we can do + a more refined determination of what to do. + + The stack format at this point is: + ---------------- + ss : (ss/esp may be present if we came from usermode) + esp : + eflags } outer exception info + cs } + eip } + ---------------- <- edi (copy dest) + eax : outer eax if it hasn't been restored + ---------------- + eflags } nested exception info + cs } (no ss/esp because we're nested + eip } from the same ring) + orig_eax }<- esi (copy src) + - - - - - - - - + fs } + es } + ds } SAVE_ALL state + eax } + : : + ebx } + ---------------- + return addr <- esp + ---------------- + + In order to deliver the nested exception properly, we need to shift + everything from the return addr up to the error code so it + sits just under the outer exception info. This means that when we + handle the exception, we do it in the context of the outer exception + rather than starting a new one. + + The only caveat is that if the outer eax hasn't been + restored yet (ie, it's still on stack), we need to insert + its value into the SAVE_ALL state before going on, since + it's usermode state which we eventually need to restore. + */ +ENTRY(xen_iret_crit_fixup) + /* offsets +4 for return address */ + + /* + Paranoia: Make sure we're really coming from userspace. + One could imagine a case where userspace jumps into the + critical range address, but just before the CPU delivers a GP, + it decides to deliver an interrupt instead. Unlikely? + Definitely. Easy to avoid? Yes. The Intel documents + explicitly say that the reported EIP for a bad jump is the + jump instruction itself, not the destination, but some virtual + environments get this wrong. + */ + movl PT_CS+4(%esp), %ecx + andl $SEGMENT_RPL_MASK, %ecx + cmpl $USER_RPL, %ecx + je 2f + + lea PT_ORIG_EAX+4(%esp), %esi + lea PT_EFLAGS+4(%esp), %edi + + /* If eip is before iret_restore_end then stack + hasn't been restored yet. */ + cmp $iret_restore_end, %eax + jae 1f + + movl 0+4(%edi),%eax /* copy EAX */ + movl %eax, PT_EAX+4(%esp) + + lea ESP_OFFSET(%edi),%edi /* move dest up over saved regs */ + + /* set up the copy */ +1: std + mov $(PT_EIP+4) / 4, %ecx /* copy ret+saved regs up to orig_eax */ + rep movsl + cld + + lea 4(%edi),%esp /* point esp to new frame */ +2: ret /* diff --git a/arch/i386/xen/xen-ops.h b/arch/i386/xen/xen-ops.h index 33e4c8a16289..b9aaea45f07f 100644 --- a/arch/i386/xen/xen-ops.h +++ b/arch/i386/xen/xen-ops.h @@ -67,4 +67,5 @@ DECL_ASM(void, xen_irq_disable_direct, void); DECL_ASM(unsigned long, xen_save_fl_direct, void); DECL_ASM(void, xen_restore_fl_direct, unsigned long); +void xen_iret_direct(void); #endif /* XEN_OPS_H */ |