diff options
Diffstat (limited to 'arch/arm/Kconfig')
| -rw-r--r-- | arch/arm/Kconfig | 51 |
1 files changed, 51 insertions, 0 deletions
diff --git a/arch/arm/Kconfig b/arch/arm/Kconfig index 184a6bd54825..3b181284970f 100644 --- a/arch/arm/Kconfig +++ b/arch/arm/Kconfig @@ -12,6 +12,7 @@ config ARM select HAVE_IDE select RTC_LIB select SYS_SUPPORTS_APM_EMULATION + select GENERIC_ATOMIC64 if (!CPU_32v6K) select HAVE_OPROFILE select HAVE_ARCH_KGDB select HAVE_KPROBES if (!XIP_KERNEL) @@ -20,6 +21,8 @@ config ARM select HAVE_GENERIC_DMA_COHERENT select HAVE_KERNEL_GZIP select HAVE_KERNEL_LZO + select HAVE_PERF_EVENTS + select PERF_USE_VMALLOC help The ARM series is a line of low-power-consumption RISC chip designs licensed by ARM Ltd and targeted at embedded applications and @@ -52,6 +55,9 @@ config HAVE_TCM bool select GENERIC_ALLOCATOR +config HAVE_PROC_CPU + bool + config NO_IOPORT bool @@ -161,6 +167,11 @@ config ARCH_MTD_XIP config GENERIC_HARDIRQS_NO__DO_IRQ def_bool y +config ARM_L1_CACHE_SHIFT_6 + bool + help + Setting ARM L1 cache line size to 64 Bytes. + if OPROFILE config OPROFILE_ARMV6 @@ -550,10 +561,20 @@ config ARCH_W90X900 <http://www.nuvoton.com/hq/enu/ProductAndSales/ProductLines/ ConsumerElectronicsIC/ARMMicrocontroller/ARMMicrocontroller> +config ARCH_NUC93X + bool "Nuvoton NUC93X CPU" + select CPU_ARM926T + select HAVE_CLK + select COMMON_CLKDEV + help + Support for Nuvoton (Winbond logic dept.) NUC93X MCU,The NUC93X is a + low-power and high performance MPEG-4/JPEG multimedia controller chip. + config ARCH_PNX4008 bool "Philips Nexperia PNX4008 Mobile" select CPU_ARM926T select HAVE_CLK + select COMMON_CLKDEV help This enables support for Philips PNX4008 mobile platform. @@ -638,6 +659,7 @@ config ARCH_S5PC1XX select GENERIC_GPIO select HAVE_CLK select CPU_V7 + select ARM_L1_CACHE_SHIFT_6 help Samsung S5PC1XX series based systems @@ -785,6 +807,8 @@ source "arch/arm/plat-nomadik/Kconfig" source "arch/arm/mach-ns9xxx/Kconfig" +source "arch/arm/mach-nuc93x/Kconfig" + source "arch/arm/plat-omap/Kconfig" source "arch/arm/mach-omap1/Kconfig" @@ -867,6 +891,11 @@ config XSCALE_PMU depends on CPU_XSCALE && !XSCALE_PMU_TIMER default y +config CPU_HAS_PMU + depends on CPU_V6 || CPU_V7 || XSCALE_PMU + default y + bool + if !MMU source "arch/arm/Kconfig-nommu" endif @@ -921,6 +950,19 @@ config ARM_ERRATA_460075 ACTLR register. Note that setting specific bits in the ACTLR register may not be available in non-secure mode. +config PL310_ERRATA_588369 + bool "Clean & Invalidate maintenance operations do not invalidate clean lines" + depends on CACHE_L2X0 && ARCH_OMAP4 + help + The PL310 L2 cache controller implements three types of Clean & + Invalidate maintenance operations: by Physical Address + (offset 0x7F0), by Index/Way (0x7F8) and by Way (0x7FC). + They are architecturally defined to behave as the execution of a + clean operation followed immediately by an invalidate operation, + both performing to the same memory location. This functionality + is not correctly implemented in PL310 as clean lines are not + invalidated as a result of these operations. Note that this errata + uses Texas Instrument's secure monitor api. endmenu source "arch/arm/common/Kconfig" @@ -1171,6 +1213,14 @@ config HIGHPTE depends on HIGHMEM depends on !OUTER_CACHE +config HW_PERF_EVENTS + bool "Enable hardware performance counter support for perf events" + depends on PERF_EVENTS && CPU_HAS_PMU && (CPU_V6 || CPU_V7) + default y + help + Enable hardware performance counter support for perf events. If + disabled, perf events will use software events only. + source "mm/Kconfig" config LEDS @@ -1230,6 +1280,7 @@ config ALIGNMENT_TRAP bool depends on CPU_CP15_MMU default y if !ARCH_EBSA110 + select HAVE_PROC_CPU if PROC_FS help ARM processors cannot fetch/store information which is not naturally aligned on the bus, i.e., a 4 byte fetch must start at an |