diff options
Diffstat (limited to 'Documentation/devicetree/bindings/mtd/ingenic,jz4780-nand.txt')
| -rw-r--r-- | Documentation/devicetree/bindings/mtd/ingenic,jz4780-nand.txt | 32 |
1 files changed, 19 insertions, 13 deletions
diff --git a/Documentation/devicetree/bindings/mtd/ingenic,jz4780-nand.txt b/Documentation/devicetree/bindings/mtd/ingenic,jz4780-nand.txt index 29ea5853ca91..c02259353327 100644 --- a/Documentation/devicetree/bindings/mtd/ingenic,jz4780-nand.txt +++ b/Documentation/devicetree/bindings/mtd/ingenic,jz4780-nand.txt @@ -1,4 +1,4 @@ -* Ingenic JZ4780 NAND/BCH +* Ingenic JZ4780 NAND/ECC This file documents the device tree bindings for NAND flash devices on the JZ4780. NAND devices are connected to the NEMC controller (described in @@ -6,15 +6,18 @@ memory-controllers/ingenic,jz4780-nemc.txt), and thus NAND device nodes must be children of the NEMC node. Required NAND controller device properties: -- compatible: Should be set to "ingenic,jz4780-nand". +- compatible: Should be one of: + * ingenic,jz4740-nand + * ingenic,jz4725b-nand + * ingenic,jz4780-nand - reg: For each bank with a NAND chip attached, should specify a bank number, an offset of 0 and a size of 0x1000000 (i.e. the whole NEMC bank). Optional NAND controller device properties: -- ingenic,bch-controller: To make use of the hardware BCH controller, this - property must contain a phandle for the BCH controller node. The required +- ecc-engine: To make use of the hardware ECC controller, this + property must contain a phandle for the ECC controller node. The required properties for this node are described below. If this is not specified, - software BCH will be used instead. + software ECC will be used instead. Optional children nodes: - Individual NAND chips are children of the NAND controller node. @@ -45,7 +48,7 @@ nemc: nemc@13410000 { #address-cells = <1>; #size-cells = <0>; - ingenic,bch-controller = <&bch>; + ecc-engine = <&bch>; nand@1 { reg = <1>; @@ -67,14 +70,17 @@ nemc: nemc@13410000 { }; }; -The BCH controller is a separate SoC component used for error correction on +The ECC controller is a separate SoC component used for error correction on NAND devices. The following is a description of the device properties for a -BCH controller. - -Required BCH properties: -- compatible: Should be set to "ingenic,jz4780-bch". -- reg: Should specify the BCH controller registers location and length. -- clocks: Clock for the BCH controller. +ECC controller. + +Required ECC properties: +- compatible: Should be one of: + * ingenic,jz4740-ecc + * ingenic,jz4725b-bch + * ingenic,jz4780-bch +- reg: Should specify the ECC controller registers location and length. +- clocks: Clock for the ECC controller. Example: |