1 files changed, 0 insertions, 212 deletions
diff --git a/Documentation/devicetree/bindings/devfreq/rk3399_dmc.txt b/Documentation/devicetree/bindings/devfreq/rk3399_dmc.txt
deleted file mode 100644
index 58fc8a6cebc7..000000000000
--- a/Documentation/devicetree/bindings/devfreq/rk3399_dmc.txt
+++ /dev/null
@@ -1,212 +0,0 @@
-* Rockchip rk3399 DMC (Dynamic Memory Controller) device
-
-Required properties:
-- compatible:		 Must be "rockchip,rk3399-dmc".
-- devfreq-events:	 Node to get DDR loading, Refer to
-			 Documentation/devicetree/bindings/devfreq/event/
-			 rockchip-dfi.txt
-- clocks:		 Phandles for clock specified in "clock-names" property
-- clock-names :		 The name of clock used by the DFI, must be
-			 "pclk_ddr_mon";
-- operating-points-v2:	 Refer to Documentation/devicetree/bindings/opp/opp-v2.yaml
-			 for details.
-- center-supply:	 DMC supply node.
-- status:		 Marks the node enabled/disabled.
-- rockchip,pmu:		 Phandle to the syscon managing the "PMU general register
-			 files".
-
-Optional properties:
-- interrupts:		 The CPU interrupt number. The interrupt specifier
-			 format depends on the interrupt controller.
-			 It should be a DCF interrupt. When DDR DVFS finishes
-			 a DCF interrupt is triggered.
-- rockchip,pmu:		 Phandle to the syscon managing the "PMU general register
-			 files".
-
-Following properties relate to DDR timing:
-
-- rockchip,dram_speed_bin :	  Value reference include/dt-bindings/clock/rk3399-ddr.h,
-				  it selects the DDR3 cl-trp-trcd type. It must be
-				  set according to "Speed Bin" in DDR3 datasheet,
-				  DO NOT use a smaller "Speed Bin" than specified
-				  for the DDR3 being used.
-
-- rockchip,pd_idle :		  Configure the PD_IDLE value. Defines the
-				  power-down idle period in which memories are
-				  placed into power-down mode if bus is idle
-				  for PD_IDLE DFI clock cycles.
-
-- rockchip,sr_idle :		  Configure the SR_IDLE value. Defines the
-				  self-refresh idle period in which memories are
-				  placed into self-refresh mode if bus is idle
-				  for SR_IDLE * 1024 DFI clock cycles (DFI
-				  clocks freq is half of DRAM clock), default
-				  value is "0".
-
-- rockchip,sr_mc_gate_idle :	  Defines the memory self-refresh and controller
-				  clock gating idle period. Memories are placed
-				  into self-refresh mode and memory controller
-				  clock arg gating started if bus is idle for
-				  sr_mc_gate_idle*1024 DFI clock cycles.
-
-- rockchip,srpd_lite_idle :	  Defines the self-refresh power down idle
-				  period in which memories are placed into
-				  self-refresh power down mode if bus is idle
-				  for srpd_lite_idle * 1024 DFI clock cycles.
-				  This parameter is for LPDDR4 only.
-
-- rockchip,standby_idle :	  Defines the standby idle period in which
-				  memories are placed into self-refresh mode.
-				  The controller, pi, PHY and DRAM clock will
-				  be gated if bus is idle for standby_idle * DFI
-				  clock cycles.
-
-- rockchip,dram_dll_dis_freq :	  Defines the DDR3 DLL bypass frequency in MHz.
-				  When DDR frequency is less than DRAM_DLL_DISB_FREQ,
-				  DDR3 DLL will be bypassed. Note: if DLL was bypassed,
-				  the odt will also stop working.
-
-- rockchip,phy_dll_dis_freq :	  Defines the PHY dll bypass frequency in
-				  MHz (Mega Hz). When DDR frequency is less than
-				  DRAM_DLL_DISB_FREQ, PHY DLL will be bypassed.
-				  Note: PHY DLL and PHY ODT are independent.
-
-- rockchip,ddr3_odt_dis_freq :	  When the DRAM type is DDR3, this parameter defines
-				  the ODT disable frequency in MHz (Mega Hz).
-				  when the DDR frequency is  less then ddr3_odt_dis_freq,
-				  the ODT on the DRAM side and controller side are
-				  both disabled.
-
-- rockchip,ddr3_drv :		  When the DRAM type is DDR3, this parameter defines
-				  the DRAM side driver strength in ohms. Default
-				  value is 40.
-
-- rockchip,ddr3_odt :		  When the DRAM type is DDR3, this parameter defines
-				  the DRAM side ODT strength in ohms. Default value
-				  is 120.
-
-- rockchip,phy_ddr3_ca_drv :	  When the DRAM type is DDR3, this parameter defines
-				  the phy side CA line (incluing command line,
-				  address line and clock line) driver strength.
-				  Default value is 40.
-
-- rockchip,phy_ddr3_dq_drv :	  When the DRAM type is DDR3, this parameter defines
-				  the PHY side DQ line (including DQS/DQ/DM line)
-				  driver strength. Default value is 40.
-
-- rockchip,phy_ddr3_odt : 	  When the DRAM type is DDR3, this parameter defines
-				  the PHY side ODT strength. Default value is 240.
-
-- rockchip,lpddr3_odt_dis_freq : When the DRAM type is LPDDR3, this parameter defines
-				  then ODT disable frequency in MHz (Mega Hz).
-				  When DDR frequency is less then ddr3_odt_dis_freq,
-				  the ODT on the DRAM side and controller side are
-				  both disabled.
-
-- rockchip,lpddr3_drv :		  When the DRAM type is LPDDR3, this parameter defines
-				  the DRAM side driver strength in ohms. Default
-				  value is 34.
-
-- rockchip,lpddr3_odt :		  When the DRAM type is LPDDR3, this parameter defines
-				  the DRAM side ODT strength in ohms. Default value
-				  is 240.
-
-- rockchip,phy_lpddr3_ca_drv :	  When the DRAM type is LPDDR3, this parameter defines
-				  the PHY side CA line (including command line,
-				  address line and clock line) driver strength.
-				  Default value is 40.
-
-- rockchip,phy_lpddr3_dq_drv :	  When the DRAM type is LPDDR3, this parameter defines
-				  the PHY side DQ line (including DQS/DQ/DM line)
-				  driver strength. Default value is 40.
-
-- rockchip,phy_lpddr3_odt : 	  When dram type is LPDDR3, this parameter define
-				  the phy side odt strength, default value is 240.
-
-- rockchip,lpddr4_odt_dis_freq : When the DRAM type is LPDDR4, this parameter
-				  defines the ODT disable frequency in
-				  MHz (Mega Hz). When the DDR frequency is less then
-				  ddr3_odt_dis_freq, the ODT on the DRAM side and
-				  controller side are both disabled.
-
-- rockchip,lpddr4_drv :		  When the DRAM type is LPDDR4, this parameter defines
-				  the DRAM side driver strength in ohms. Default
-				  value is 60.
-
-- rockchip,lpddr4_dq_odt : 	  When the DRAM type is LPDDR4, this parameter defines
-				  the DRAM side ODT on DQS/DQ line strength in ohms.
-				  Default value is 40.
-
-- rockchip,lpddr4_ca_odt :	  When the DRAM type is LPDDR4, this parameter defines
-				  the DRAM side ODT on CA line strength in ohms.
-				  Default value is 40.
-
-- rockchip,phy_lpddr4_ca_drv :	  When the DRAM type is LPDDR4, this parameter defines
-				  the PHY side CA line (including command address
-				  line) driver strength. Default value is 40.
-
-- rockchip,phy_lpddr4_ck_cs_drv : When the DRAM type is LPDDR4, this parameter defines
-				  the PHY side clock line and CS line driver
-				  strength. Default value is 80.
-
-- rockchip,phy_lpddr4_dq_drv :	  When the DRAM type is LPDDR4, this parameter defines
-				  the PHY side DQ line (including DQS/DQ/DM line)
-				  driver strength. Default value is 80.
-
-- rockchip,phy_lpddr4_odt :	  When the DRAM type is LPDDR4, this parameter defines
-				  the PHY side ODT strength. Default value is 60.
-
-Example:
-	dmc_opp_table: dmc_opp_table {
-		compatible = "operating-points-v2";
-
-		opp00 {
-			opp-hz = /bits/ 64 <300000000>;
-			opp-microvolt = <900000>;
-		};
-		opp01 {
-			opp-hz = /bits/ 64 <666000000>;
-			opp-microvolt = <900000>;
-		};
-	};
-
-	dmc: dmc {
-		compatible = "rockchip,rk3399-dmc";
-		devfreq-events = <&dfi>;
-		interrupts = <GIC_SPI 1 IRQ_TYPE_LEVEL_HIGH>;
-		clocks = <&cru SCLK_DDRC>;
-		clock-names = "dmc_clk";
-		operating-points-v2 = <&dmc_opp_table>;
-		center-supply = <&ppvar_centerlogic>;
-		upthreshold = <15>;
-		downdifferential = <10>;
-		rockchip,ddr3_speed_bin = <21>;
-		rockchip,pd_idle = <0x40>;
-		rockchip,sr_idle = <0x2>;
-		rockchip,sr_mc_gate_idle = <0x3>;
-		rockchip,srpd_lite_idle	= <0x4>;
-		rockchip,standby_idle = <0x2000>;
-		rockchip,dram_dll_dis_freq = <300>;
-		rockchip,phy_dll_dis_freq = <125>;
-		rockchip,auto_pd_dis_freq = <666>;
-		rockchip,ddr3_odt_dis_freq = <333>;
-		rockchip,ddr3_drv = <40>;
-		rockchip,ddr3_odt = <120>;
-		rockchip,phy_ddr3_ca_drv = <40>;
-		rockchip,phy_ddr3_dq_drv = <40>;
-		rockchip,phy_ddr3_odt = <240>;
-		rockchip,lpddr3_odt_dis_freq = <333>;
-		rockchip,lpddr3_drv = <34>;
-		rockchip,lpddr3_odt = <240>;
-		rockchip,phy_lpddr3_ca_drv = <40>;
-		rockchip,phy_lpddr3_dq_drv = <40>;
-		rockchip,phy_lpddr3_odt = <240>;
-		rockchip,lpddr4_odt_dis_freq = <333>;
-		rockchip,lpddr4_drv = <60>;
-		rockchip,lpddr4_dq_odt = <40>;
-		rockchip,lpddr4_ca_odt = <40>;
-		rockchip,phy_lpddr4_ca_drv = <40>;
-		rockchip,phy_lpddr4_ck_cs_drv = <80>;
-		rockchip,phy_lpddr4_dq_drv = <80>;
-		rockchip,phy_lpddr4_odt = <60>;
-	};