diff options
| -rw-r--r-- | drivers/net/ixgbe/ixgbe_main.c | 24 |
1 files changed, 4 insertions, 20 deletions
diff --git a/drivers/net/ixgbe/ixgbe_main.c b/drivers/net/ixgbe/ixgbe_main.c index 3d5f7f575ae3..e52798c4816b 100644 --- a/drivers/net/ixgbe/ixgbe_main.c +++ b/drivers/net/ixgbe/ixgbe_main.c @@ -411,6 +411,9 @@ static void ixgbe_setup_dca(struct ixgbe_adapter *adapter) if (!(adapter->flags & IXGBE_FLAG_DCA_ENABLED)) return; + /* always use CB2 mode, difference is masked in the CB driver */ + IXGBE_WRITE_REG(&adapter->hw, IXGBE_DCA_CTRL, 2); + for (i = 0; i < adapter->num_tx_queues; i++) { adapter->tx_ring[i].cpu = -1; ixgbe_update_tx_dca(adapter, &adapter->tx_ring[i]); @@ -432,9 +435,6 @@ static int __ixgbe_notify_dca(struct device *dev, void *data) /* if we're already enabled, don't do it again */ if (adapter->flags & IXGBE_FLAG_DCA_ENABLED) break; - /* Always use CB2 mode, difference is masked - * in the CB driver. */ - IXGBE_WRITE_REG(&adapter->hw, IXGBE_DCA_CTRL, 2); if (dca_add_requester(dev) == 0) { adapter->flags |= IXGBE_FLAG_DCA_ENABLED; ixgbe_setup_dca(adapter); @@ -2767,13 +2767,6 @@ void ixgbe_down(struct ixgbe_adapter *adapter) netif_carrier_off(netdev); -#ifdef CONFIG_IXGBE_DCA - if (adapter->flags & IXGBE_FLAG_DCA_ENABLED) { - adapter->flags &= ~IXGBE_FLAG_DCA_ENABLED; - dca_remove_requester(&adapter->pdev->dev); - } - -#endif if (!pci_channel_offline(adapter->pdev)) ixgbe_reset(adapter); ixgbe_clean_all_tx_rings(adapter); @@ -2781,13 +2774,7 @@ void ixgbe_down(struct ixgbe_adapter *adapter) #ifdef CONFIG_IXGBE_DCA /* since we reset the hardware DCA settings were cleared */ - if (dca_add_requester(&adapter->pdev->dev) == 0) { - adapter->flags |= IXGBE_FLAG_DCA_ENABLED; - /* always use CB2 mode, difference is masked - * in the CB driver */ - IXGBE_WRITE_REG(hw, IXGBE_DCA_CTRL, 2); - ixgbe_setup_dca(adapter); - } + ixgbe_setup_dca(adapter); #endif } @@ -5354,9 +5341,6 @@ static int __devinit ixgbe_probe(struct pci_dev *pdev, #ifdef CONFIG_IXGBE_DCA if (dca_add_requester(&pdev->dev) == 0) { adapter->flags |= IXGBE_FLAG_DCA_ENABLED; - /* always use CB2 mode, difference is masked - * in the CB driver */ - IXGBE_WRITE_REG(hw, IXGBE_DCA_CTRL, 2); ixgbe_setup_dca(adapter); } #endif |