Merge tag 'spi-3.6' of git://git.kernel.org/pub/scm/linux/kernel/git/broonie/misc

Pull spi updates from Mark Brown:
 "Since Grant is even more specacularly busy than usual for the time
  being I've been collecting SPI patches for him for this release -
  probably things will revert back to Grant before the next release.

  There's nothing too exciting here, mostly it's simple driver specific
  stuff:

   - Add spi: to the modaliases of SPI devices to provide namespacing.
   - A driver for AD-FMCOMMS1-EBZ.
   - DT binding for Orion.
   - Fixes and cleanups for i.MX, PL0022, OMAP and bitbang drivers.

   There may be a few more fixes I've missed, people keep sending me new
   things."

* tag 'spi-3.6' of git://git.kernel.org/pub/scm/linux/kernel/git/broonie/misc:
  spi/orion: remove uneeded spi_info
  spi/bcm63xx: fix clock configuration selection
  spi/orion: add device tree binding
  spi/omap2: mark omap2_mcspi_master_setup as __devinit
  spi: omap2-mcspi: Fix the below warning
  spi: Add AD-FMCOMMS1-EBZ I2C-SPI bridge driver
  spi/imx: use gpio_is_valid to determine if a gpio is valid
  spi/imx: remove redundant config.speed_hz setting
  spi/gpio: start with CS non-active
  spi: tegra: use dmaengine based dma driver
  spi/pl022: cleanup pl022 header documentation
  spi/pl022: enable runtime PM
  spi/pl022: delete DB5500 support
  spi/pl022: disable port when unused
  spi: Add "spi:" prefix to modalias attribute of spi devices

1 files changed, 1 insertions, 8 deletions

diff --git a/include/linux/amba/pl022.h b/include/linux/amba/pl022.h
index 76dd1b199a1b..fe1d7b283cb6 100644
--- a/include/linux/amba/pl022.h
+++ b/include/linux/amba/pl022.h
@@ -231,6 +231,7 @@ enum ssp_chip_select {
 struct dma_chan;
 /**
  * struct pl022_ssp_master - device.platform_data for SPI controller devices.
+ * @bus_id: identifier for this bus
  * @num_chipselect: chipselects are used to distinguish individual
  *     SPI slaves, and are numbered from zero to num_chipselects - 1.
  *     each slave has a chipselect signal, but it's common that not
@@ -259,19 +260,13 @@ struct pl022_ssp_controller {
  * struct ssp_config_chip - spi_board_info.controller_data for SPI
  * slave devices, copied to spi_device.controller_data.
  *
- * @lbm: used for test purpose to internally connect RX and TX
  * @iface: Interface type(Motorola, TI, Microwire, Universal)
  * @hierarchy: sets whether interface is master or slave
  * @slave_tx_disable: SSPTXD is disconnected (in slave mode only)
  * @clk_freq: Tune freq parameters of SSP(when in master mode)
- * @endian_rx: Endianess of Data in Rx FIFO
- * @endian_tx: Endianess of Data in Tx FIFO
- * @data_size: Width of data element(4 to 32 bits)
  * @com_mode: communication mode: polling, Interrupt or DMA
  * @rx_lev_trig: Rx FIFO watermark level (for IT & DMA mode)
  * @tx_lev_trig: Tx FIFO watermark level (for IT & DMA mode)
- * @clk_phase: Motorola SPI interface Clock phase
- * @clk_pol: Motorola SPI interface Clock polarity
  * @ctrl_len: Microwire interface: Control length
  * @wait_state: Microwire interface: Wait state
  * @duplex: Microwire interface: Full/Half duplex
@@ -279,8 +274,6 @@ struct pl022_ssp_controller {
  * before sampling the incoming line
  * @cs_control: function pointer to board-specific function to
  * assert/deassert I/O port to control HW generation of devices chip-select.
- * @dma_xfer_type: Type of DMA xfer (Mem-to-periph or Periph-to-Periph)
- * @dma_config: DMA configuration for SSP controller and peripheral
  */
 struct pl022_config_chip {
 	enum ssp_interface iface;