PM / PCI / ACPI: Kick devices that might have been reset by firmware

There is a concern that if the platform firmware was involved in
the system resume that's being completed,  some devices might have
been reset by it and if those devices had the power.direct_complete
flag set during the preceding suspend transition, they may stay
in a reset-power-on state indefinitely (until they are runtime-resumed
and then suspended again).  That may not be a big deal from the
individual device's perspective, but if the system is an SoC, it may
be prevented from entering deep SoC-wide low-power states on idle
because of that.

The devices that are most likely to be affected by this issue are
PCI devices and ACPI-enumerated devices using the general ACPI PM
domain, so to prevent it from happening for those devices, force a
runtime resume for them if they have their power.direct_complete
flags set and the platform firmware was involved in the resume
transition currently in progress.

Signed-off-by: Rafael J. Wysocki <rafael.j.wysocki@intel.com>

1 files changed, 1 insertions, 1 deletions

diff --git a/drivers/acpi/acpi_lpss.c b/drivers/acpi/acpi_lpss.c
index f51bd0d0bc17..f9e0d09f7c66 100644
--- a/drivers/acpi/acpi_lpss.c
+++ b/drivers/acpi/acpi_lpss.c
@@ -664,7 +664,7 @@ static struct dev_pm_domain acpi_lpss_pm_domain = {
 #ifdef CONFIG_PM
 #ifdef CONFIG_PM_SLEEP
 		.prepare = acpi_subsys_prepare,
-		.complete = acpi_subsys_complete,
+		.complete = pm_complete_with_resume_check,
 		.suspend = acpi_subsys_suspend,
 		.suspend_late = acpi_lpss_suspend_late,
 		.resume_early = acpi_lpss_resume_early,