OMAP2+: powerdomain: move header file from plat-omap to mach-omap2

The OMAP powerdomain code and data is all OMAP2+-specific.  This seems
unlikely to change any time soon.  Move plat-omap/include/plat/powerdomain.h
to mach-omap2/powerdomain.h.  The primary point of doing this is to remove
the temptation for unrelated upper-layer code to access powerdomain code
and data directly.

As part of this process, remove the references to powerdomain data
from the GPIO "driver" and the OMAP PM no-op layer, both in plat-omap.
Change the DSPBridge code to point to the new location for the
powerdomain headers.  The DSPBridge code should not be including the
powerdomain headers; these should be removed.

Signed-off-by: Paul Walmsley <paul@pwsan.com>
Cc: Kevin Hilman <khilman@deeprootsystems.com>
Cc: Omar Ramirez Luna <omar.ramirez@ti.com>
Cc: Felipe Contreras <felipe.contreras@gmail.com>
Cc: Greg Kroah-Hartman <greg@kroah.com>

1 files changed, 2 insertions, 2 deletions

diff --git a/arch/arm/mach-omap2/pm24xx.c b/arch/arm/mach-omap2/pm24xx.c
index f6aef7687b8a..2844b84f8d46 100644
--- a/arch/arm/mach-omap2/pm24xx.c
+++ b/arch/arm/mach-omap2/pm24xx.c
@@ -50,7 +50,7 @@
 #include "pm.h"
 #include "control.h"
 
-#include <plat/powerdomain.h>
+#include "powerdomain.h"
 #include "clockdomain.h"
 
 #ifdef CONFIG_SUSPEND
@@ -120,7 +120,7 @@ static void omap2_enter_full_retention(void)
 	l = omap_ctrl_readl(OMAP2_CONTROL_DEVCONF0) | OMAP24XX_USBSTANDBYCTRL;
 	omap_ctrl_writel(l, OMAP2_CONTROL_DEVCONF0);
 
-	omap2_gpio_prepare_for_idle(PWRDM_POWER_RET);
+	omap2_gpio_prepare_for_idle(0);
 
 	if (omap2_pm_debug) {
 		omap2_pm_dump(0, 0, 0);